ACP Technologies|sublimation| dye, printer, blanks| Unisub Vapor Premiere Powered by JRank
Dedicated to all your Digital Decorating needs
Contact Us   |   View Cart
Sublimation Support - Pressing Aluminum

Heat Pressing Info

 

Unisub Aluminum

 

1) Preheat press to 400F and set to medium pressure

2) Secure transfer by wrapping the transfer around the metal and taping it to the back of the metal
3) Place a clean sheet of plain paper on the heat press table (optional)
4) Place metal face-up on the press
5) Heat Unisub Aluminum 60 seconds adjusting time as necessary for best results.
 
 

 
 
Dynasub Aluminum

 

1) Preheat press to 385F and set to medium pressure
2) Secure transfer by wrapping the transfer around the metal and taping it to the back of the metal

3) Place a clean sheet of plain paper on the heat press table (optional)

4) Place metal face-up on the press
5) Heat Dynasub Aluminum 35 secondsadjusting time as necessary for best results.
 
 

 
 
TCS Aluminum

 

1) Preheat press to 375F and set to medium pressure
2) Secure transfer by wrapping the transfer around the metal and taping it to the back of the metal

3) Place a clean sheet of plain paper on the heat press table (optional)

4) Place metal face-up on the press
5) Heat TCH White Aluminum 50 seconds adjusting time as necessary for best results.
6) Remove transfer immediately to prevent paper residue.
 
 

 
The information contained herein is included for illustrative purposes only and, to the best of our knowledge, is accurate and reliable.  ACP Technologies cannot, however, under any circumstances make any guarantee of results or assume any obligation or liability in connection with the use of this information.  As ACP has no control over the use to which others may put its products, it is recommended that the products be tested to determine if suitable for a specific application and/or information is valid in a particular circumstance.  Responsibility remains with owner for the design, application and proper installation of each product.  Specifier and user shall determine suitability of products for a specific application and assume all responsibility in connection therewith.


  Customer Service: 1-800-741-2551
 
 
425 Cross St. - Ste 213, Punta Gorda, FL  33950

 
MonFri 9am-5pm EST
 
2017 ACP Technologies. All rights reserved.