ACP Technologies|sublimation| dye, printer, blanks| Unisub Vapor Premiere Powered by JRank
Dedicated to all your Digital Decorating needs
Contact Us   |   View Cart
 

Heat Pressing Info

 

Beverage Holder

 

1) For double-sided imprinting with full bleed start by creating two 5” x 6.25” rectangles side by side to define the layout in your graphic design software.

2) Create two 4” x 5.25” rectangles (dashed lines in diagram) and position each one in the center of each of the larger rectangles
3) Create two rectangles 3.818” x 3.818” and center them in the rectangles created in step 2, but move them almost to the top
4) For full bleed, insert or PowerClip background image into the 5” x 6.26” rectangles
5) Logos and text should be placed in the smallest  3.818” x 3.818” rectangles
6) Preheat press to 400°F and set to medium pressure
7) Place a clean sheet of plain paper on the heat press table (optional)
8) Fold transfer on center line, then place Beverage Holder in the area represented by the dashed lines, secure with spray adhesive and place in heat press

9) Heat for 45 seconds adjusting time as necessary for best results

 
 

 
 
Beverage Holder Transfer Diagram
 

Remember to remove the outlines in your graphic before printing
When pressed, the holder will be squeezed to a larger size
For your convenience, a CorelDRAW template for the Beverage Holder can be sent to you via e-mail
 
 
 

 

The information contained herein is included for illustrative purposes only and, to the best of our knowledge, is accurate and reliable.  ACP Technologies cannot, however, under any circumstances make any guarantee of results or assume any obligation or liability in connection with the use of this information.  As ACP has no control over the use to which others may put its products, it is recommended that the products be tested to determine if suitable for a specific application and/or information is valid in a particular circumstance.  Responsibility remains with owner for the design, application and proper installation of each product.  Specifier and user shall determine suitability of products for a specific application and assume all responsibility in connection therewith.


  Customer Service: 1-800-741-2551
 
 
425 Cross St. - Ste 213, Punta Gorda, FL  33950

 
Mon–Fri 9am-5pm EST
 
©2017 ACP Technologies. All rights reserved.