ACP Technologies|sublimation| dye, printer, blanks| Unisub Vapor Premiere Powered by JRank
Dedicated to all your Digital Decorating needs
Contact Us   |   View Cart
 

Heat Pressing Info

 

Mates - New White

 

1)  Preheat press to 400°F and set to medium to heavy pressure

2)  Cut MATES to size and secure transfer with heat tape.
3)  Place in press with backing down on a clean sheet of paper.
4)  Place a second clean sheet of paper on top.
5)  Press for 60 - 70 seconds adjusting time as necessary for best results.
6) Remove the transfer, peel off backing and stick MATES to create signs, awards, promotional products, labels and more.
 
 

 

The information contained herein is included for illustrative purposes only and, to the best of our knowledge, is accurate and reliable.  ACP Technologies cannot, however, under any circumstances make any guarantee of results or assume any obligation or liability in connection with the use of this information.  As ACP has no control over the use to which others may put its products, it is recommended that the products be tested to determine if suitable for a specific application and/or information is valid in a particular circumstance.  Responsibility remains with owner for the design, application and proper installation of each product.  Specifier and user shall determine suitability of products for a specific application and assume all responsibility in connection therewith.


  Customer Service: 1-800-741-2551
 
 
425 Cross St. - Ste 213, Punta Gorda, FL  33950

 
Mon–Fri 9am-5pm EST
 
©2017 ACP Technologies. All rights reserved.