ACP Technologies|sublimation| dye, printer, blanks| Unisub Vapor Premiere Powered by JRank
Dedicated to all your Digital Decorating needs
Contact Us   |   View Cart
 

Heat Pressing Info

 

Gloss PrimaTiles

 

1) Preheat press to 400° and set to light pressure

2) Place a clean sheet of plain paper on the heat press table (optional)
3) Secure the transfer to the back of the tile with heat tape
4) Place tile face-up in heat press
5) Place a plain sheet of paper on top
6) Place Heat Conductive Rubber on top
7) Heat for 6-8 minutes adjusting time as necessary for best results (SubliJet XG8 inks - 5 minutes)
 

Please Note: 

- The above instructions are recommended for tiles up to 6x8

- 8x10 and larger tiles may require one or two minutes additional heat time - XG8 Black ink can be overheated, increase time only as needed

 
 

 
 
Satin / Matte PrimaTiles
 

1) Preheat press to 400° and set to medium to heavy pressure

2) Place a clean sheet of plain paper on the heat press table (optional)

3) Secure the transfer to the back of the tile with heat tape
4) Place tile face-up in heat press
5) Place a plain sheet of paper on top
6) Place Heat Conductive Rubber on top
7) Heat for 6-8 minutes adjusting time as necessary for best results (SubliJet XG8 inks - 5 minutes)

 

Please Note: 

- The above instructions are recommended for tiles up to 6x8

- 8x10 and larger tiles may require one or two minutes additional heat time - XG8 Black ink can be overheated, increase time only as needed

 
 

 
 
Porcelain PrimaTiles
 

1) Preheat press to 400° and set to medium to heavy pressure

2) Place a clean sheet of plain paper on the heat press table (optional)

3) Secure the transfer to the back of the tile with heat tape
4) Place tile face-up in heat press
5) Place a plain sheet of paper on top
6) Place Heat Conductive Rubber on top
7) Heat for 6-8 minutes adjusting time as necessary for best results (SubliJet XG8 inks - 5 minutes)

 

Please Note: 

- The above instructions are recommended for tiles up to 6x8

- 8x10 and larger tiles may require one or two minutes additional heat time - XG8 Black ink can be overheated, increase time only as needed

 
 

 
The information contained herein is included for illustrative purposes only and, to the best of our knowledge, is accurate and reliable.  ACP Technologies cannot, however, under any circumstances make any guarantee of results or assume any obligation or liability in connection with the use of this information.  As ACP has no control over the use to which others may put its products, it is recommended that the products be tested to determine if suitable for a specific application and/or information is valid in a particular circumstance.  Responsibility remains with owner for the design, application and proper installation of each product.  Specifier and user shall determine suitability of products for a specific application and assume all responsibility in connection therewith.


  Customer Service: 1-800-741-2551
 
Mon–Fri 9am-5pm EST
 
425 Cross St. - Ste 213, Punta Gorda, FL  33950
Sign up for our newsletter
 
Sublimation Solutions® is a registered trademark.
 
©2011 ACP Technologies. All rights reserved.