ACP Technologies|sublimation| dye, printer, blanks| Unisub Vapor Premiere Powered by JRank
Dedicated to all your Digital Decorating needs
Contact Us   |   View Cart
 

Heat Pressing Info

 

Vapor Apparel - Micro Fiber

 

1) Preheat press to 390°F and set to medium pressure

2) Use a lint roller over the surface of the garment that will come into contact with heat to remove any lint, dust or loose fibers that may have settled on the fabric
3) Place a clean sheet of plain paper on the heat press table (optional)
4) Place t-shirt face-up on press - you should not experience blow-through when you are heating Vapor Apparel, if you do, you could dress the press, or  place a clean sheet of plain paper between the front & back of the shirt
5) Apply the transfer face-down on the fabric securing the transfer with spray adhesive (spray adhesive optional)
6) Place an additional sheet of paper on top of the transfer to completely cover the shirt from exposure to the heat platen (optional)
7) Press for 35 seconds adjusting time as necessary for best result
 
 

 
 
Please Note:

-  Check your transfer for extraneous ink around the edges of the paper - cut off the edge if necessary

-  Keep your heat press clean – Residual ink on your heat press can result in unwanted “stray” spots on your fabric

 
 

 

The information contained herein is included for illustrative purposes only and, to the best of our knowledge, is accurate and reliable.  ACP Technologies cannot, however, under any circumstances make any guarantee of results or assume any obligation or liability in connection with the use of this information.  As ACP has no control over the use to which others may put its products, it is recommended that the products be tested to determine if suitable for a specific application and/or information is valid in a particular circumstance.  Responsibility remains with owner for the design, application and proper installation of each product.  Specifier and user shall determine suitability of products for a specific application and assume all responsibility in connection therewith.


  Customer Service: 1-800-741-2551
 
 
425 Cross St. - Ste 213, Punta Gorda, FL  33950

 
Mon–Fri 9am-5pm EST
 
©2017 ACP Technologies. All rights reserved.